HF Blister Packaging Machine installation and commissioning are as follows:
(A), installation procedures:
1, the welder should be placed in a solid, horizontal table. The machine should be left behind more than 150mm of space, to facilitate ventilation and heat.
2, to ensure safe operation, the machine must be grounded, the ground resistance must be less than 4 ohms. 3, the three control wires were inserted into the rear of the three ends of the welding socket, and tighten the nut.
4. Place the selector switch in the manual position.
5, lock the four screws to lift, to fix the ultrasonic vibration, but not excessive force, so as not to slip teeth.
6, the welding die and the ultrasonic vibration of the contact surface wipe clean, with the screw, the use of random wrench lock, locking force of 25 Newton / m. 7, the external air supply of the trachea access welding machine air filter.
8, sound wave inspection procedures: to play the best use of welding effect, maintenance of the performance and safety of welding machine, the use of machines or replace the welding mold, you must adjust the vibration of the welding system and vibration system vibration degree, so The sound wave detection program is very important.
A, before testing, both on the welding and ultrasonic vibration head must be tightly locked, the test did not touch the workpiece on the welding die.
B, turn on the power switch, then the power indicator light.
C, open the side door of the door.
D, the selection switch to the sound wave detection file position, observe the amplitude table of the indicated value, each sound detection switch can not be pressed more than 3 seconds.
E, the reverse rotation of the High Frequency Welding sound wave detection screw so that the amplitude table pointer at the lowest scale value position. Note: The amplitude table pointer can be adjusted to 1.2 (or 100) scale value below, and to ensure that the lowest scale position, the welder vibration system and vibration system spectrum vibration is best.
(A), installation procedures:
1, the welder should be placed in a solid, horizontal table. The machine should be left behind more than 150mm of space, to facilitate ventilation and heat.
2, to ensure safe operation, the machine must be grounded, the ground resistance must be less than 4 ohms. 3, the three control wires were inserted into the rear of the three ends of the welding socket, and tighten the nut.
4. Place the selector switch in the manual position.
5, lock the four screws to lift, to fix the ultrasonic vibration, but not excessive force, so as not to slip teeth.
6, the welding die and the ultrasonic vibration of the contact surface wipe clean, with the screw, the use of random wrench lock, locking force of 25 Newton / m. 7, the external air supply of the trachea access welding machine air filter.
8, sound wave inspection procedures: to play the best use of welding effect, maintenance of the performance and safety of welding machine, the use of machines or replace the welding mold, you must adjust the vibration of the welding system and vibration system vibration degree, so The sound wave detection program is very important.
A, before testing, both on the welding and ultrasonic vibration head must be tightly locked, the test did not touch the workpiece on the welding die.
B, turn on the power switch, then the power indicator light.
C, open the side door of the door.
D, the selection switch to the sound wave detection file position, observe the amplitude table of the indicated value, each sound detection switch can not be pressed more than 3 seconds.
E, the reverse rotation of the High Frequency Welding sound wave detection screw so that the amplitude table pointer at the lowest scale value position. Note: The amplitude table pointer can be adjusted to 1.2 (or 100) scale value below, and to ensure that the lowest scale position, the welder vibration system and vibration system spectrum vibration is best.